2004 Acura MDX Lug Nut Torque Specifications
Introduction
When it comes to maintaining your vehicle’s safety and performance, proper torque specifications for lug nuts are crucial. This article will provide you with the recommended lug nut torque specifications for a 2004 Acura MDX, ensuring that you tighten your lug nuts to the appropriate level.
Lug Nut Torque Specifications
To prevent over-tightening or under-tightening, it is important to follow the manufacturer’s recommended torque specifications. The table below outlines the lug nut torque specifications for a 2004 Acura MDX:
| Lug Nut | Torque (lb. ft) | Torque (Nm) |
|---|---|---|
| Front | 80-94 | 108-128 |
| Rear | 80-94 | 108-128 |
Procedure
To ensure the lug nuts are properly tightened, follow these steps:
- Using a lug wrench or a torque wrench, loosen the lug nuts on the wheel you wish to remove.
- With the vehicle raised securely on a jack stand, remove the wheel.
- Clean the wheel stud threads and the lug nuts to remove any dirt or debris.
- Place the wheel back onto the wheel hub, aligning the lug nut holes with the wheel studs.
- Hand-tighten the lug nuts until they are snug.
- Using a torque wrench, tighten the lug nuts in a crisscross pattern to the specified torque value according to the table above.
- Double-check the lug nuts to ensure they are all tightened to the correct torque.
- Repeat the process for each wheel.
Conclusion
Properly torquing the lug nuts on your 2004 Acura MDX is essential for your safety and the longevity of your vehicle. By following the recommended torque specifications provided in this article, you can ensure that your lug nuts are tightened to the appropriate level, providing you with peace of mind while driving. Remember to always consult your vehicle’s manual or a trusted source for the most accurate and up-to-date torque specifications.
