2017 Honda Accord Lug Nut Torque
Introduction
When it comes to maintaining your vehicle, it’s important to pay attention to even the smallest details. One such detail is the torque specification for your Honda Accord’s lug nuts. Properly torquing the lug nuts ensures that your wheels are securely fastened, preventing any accidents or damage while driving. In this article, we will discuss the lug nut torque specifications for the 2017 Honda Accord.
Lug Nut Torque Specifications
To ensure the correct torque is applied to your Honda Accord’s lug nuts, it’s essential to follow the manufacturer’s recommendations. The table below provides the lug nut torque specifications in both pound-feet (lb. ft) and Newton meters (Nm) for the 2017 Honda Accord:
| Lug Nut Position | Torque Specification (lb. ft) | Torque Specification (Nm) |
|---|---|---|
| Front and Rear Wheel Lug Nuts | 80 lb. ft | 108 Nm |
| Spare Wheel Lug Nuts | 80 lb. ft | 108 Nm |
Steps to Properly Torque Lug Nuts
Now that you know the correct torque specifications for your Honda Accord’s lug nuts, let’s go through the steps to properly torque them:
- Start by parking your vehicle on a flat surface and engaging the parking brake.
- Using a lug wrench or a suitable socket and torque wrench, loosen each lug nut on the wheel you intend to work on, but do not remove them completely.
- Position the jack under the vehicle’s recommended jacking point and lift the wheel off the ground. Make sure to follow the instructions provided in your vehicle’s owner’s manual.
- Completely remove the loosened lug nuts and carefully take off the wheel.
- Inspect the wheel and brake components for any signs of damage or wear. This is also a good opportunity to clean the wheel and hub surface.
- Place the wheel back onto the hub, aligning the lug nut holes with the studs.
- Hand-tighten each lug nut as much as possible to ensure proper alignment.
- Using a torque wrench, tighten each lug nut in a crisscross pattern. Gradually increase the torque until you reach the specified value.
- Double-check the lug nuts to ensure they are all tightened to the correct torque specification.
- Lower the vehicle using the jack and remove the jack from under the car.
- Finally, use a torque wrench to recheck the lug nut torque after driving a short distance to ensure they haven’t loosened.
Conclusion
Properly torquing the lug nuts of your 2017 Honda Accord is crucial for the safety and performance of your vehicle. By following the manufacturer’s recommended torque specifications and using the correct procedure, you can ensure that your wheels are securely fastened. Regularly checking the lug nut torque and maintaining it within the specified range will help prevent any potential accidents or damage caused by loose wheels.
