About Lug Nut Torque
Properly torquing the lug nuts on your vehicle’s wheels is crucial for safety and to prevent damage. Lug nut torque refers to the amount of force applied to tighten the lug nuts, ensuring they are secure and won’t loosen while driving. It is important to follow the manufacturer’s recommended torque specifications to avoid over-tightening or under-tightening the lug nuts.
2020 Honda Pilot Lug Nut Torque Specifications
Here are the lug nut torque specifications for the 2020 Honda Pilot:
| Lug Nut Size | Torque (lb. ft) | Torque (Nm) |
|---|---|---|
| 14mm x 1.5 | 80-90 | 108-122 |
| 12mm x 1.5 | 70-80 | 95-108 |
How to Properly Torque Lug Nuts
Step 1: Gather the Required Tools
Before you begin, make sure you have the following tools:
- Torque wrench
- Lug nut socket
Step 2: Loosen the Lug Nuts
Using a lug nut socket and a breaker bar or a lug wrench, loosen the lug nuts on each wheel. Do not remove them completely at this stage.
Step 3: Jack up the Vehicle
Using a hydraulic jack or a car lift, raise the vehicle until the wheel you are working on is off the ground. Make sure to follow proper safety procedures and use jack stands to secure the vehicle before working underneath it.
Step 4: Remove the Lug Nuts
Once the vehicle is safely lifted, remove the lug nuts completely and take off the wheel.
Step 5: Clean the Wheel Studs
Inspect the wheel studs for any dirt, debris, or rust. Clean them using a wire brush if necessary to ensure a proper connection between the lug nuts and the wheel hub.
Step 6: Install the Wheel
Place the wheel back onto the wheel hub and hand-tighten the lug nuts in a star pattern to ensure even tightening.
Step 7: Torque the Lug Nuts
Using a torque wrench and the appropriate lug nut socket, tighten the lug nuts to the manufacturer’s recommended torque specification. Refer to the table above for the specific torque values for your 2020 Honda Pilot.
Step 8: Lower the Vehicle
Once all the lug nuts are properly torqued, carefully lower the vehicle back to the ground using the hydraulic jack or car lift.
Step 9: Double Check the Lug Nuts
After lowering the vehicle, double-check the lug nuts to ensure they are still properly torqued. Give each lug nut a final check to make sure they are secure.
Step 10: Repeat for Other Wheels
Repeat the above steps for each wheel on your 2020 Honda Pilot, ensuring that all lug nuts are torqued to the manufacturer’s specifications.
Conclusion
Properly torquing the lug nuts on your 2020 Honda Pilot is essential for safety and to prevent any potential issues. By following the manufacturer’s recommended torque specifications and using the correct tools, you can ensure that your wheels are securely fastened. Remember to periodically check the lug nut torque to maintain the safety and performance of your vehicle.
