2020 Nissan Altima Lug Nut Torque: A Comprehensive Guide
Introduction
When it comes to maintaining your vehicle, one crucial aspect is ensuring that the lug nuts are properly tightened. The lug nuts secure the wheels to the vehicle’s hub, and if not torqued correctly, it can lead to various issues such as wheel imbalance, vibrations, or even wheel detachment. In this article, we will discuss the recommended lug nut torque specifications for the 2020 Nissan Altima.
Lug Nut Torque Specifications
To ensure the safe and proper installation of your Nissan Altima’s wheels, it is essential to adhere to the manufacturer’s recommended lug nut torque specifications. These specifications indicate the amount of force in pound-feet (lb. ft) or Newton meters (Nm) required to tighten the lug nuts adequately. Below is a table outlining the lug nut torque specs for the 2020 Nissan Altima:
| Lug Nut Position | Torque Specification (lb. ft) | Torque Specification (Nm) |
|---|---|---|
| Front and Rear Wheels | 80-100 lb. ft | 108-135 Nm |
Steps to Properly Torque Lug Nuts
To ensure the lug nuts are tightened correctly, follow these steps:
- Start by parking your Nissan Altima on a level surface and engaging the parking brake.
- Using a lug wrench or a torque wrench, loosen each lug nut on the wheel by turning them counterclockwise.
- Once all the lug nuts are loosened, use a jack to lift the vehicle off the ground, following the instructions provided in your owner’s manual.
- Remove the loosened lug nuts and carefully take off the wheel.
- Clean the wheel hub and the mounting surface to ensure proper contact and prevent any debris from interfering with the lug nut tightening process.
- Place the wheel back onto the hub, aligning the holes with the lug studs.
- Hand-tighten each lug nut until they are snug against the wheel.
- Using a torque wrench, tighten the lug nuts in a star pattern to ensure even distribution of torque. Refer to the torque specifications mentioned in the table above.
- Once all the lug nuts are torqued correctly, lower the vehicle back to the ground using the jack.
- Finally, using the torque wrench, double-check the lug nuts’ torque to ensure they are properly tightened.
Conclusion
Properly torquing the lug nuts of your 2020 Nissan Altima is crucial for your safety and the longevity of your vehicle. By adhering to the recommended torque specifications and following the steps outlined above, you can ensure that your wheels are securely fastened. Remember to consult your vehicle’s owner’s manual for any specific instructions or torque specifications.
