2017 Nissan Sentra Lug Nut Torque
Introduction
When it comes to maintaining your vehicle, one important aspect to consider is the torque specifications for lug nuts. Properly torquing the lug nuts on your 2017 Nissan Sentra is crucial for ensuring the safety and longevity of your wheels. In this article, we will provide you with the recommended lug nut torque specifications for your Nissan Sentra.
Lug Nut Torque Specifications
To avoid over-tightening or under-tightening the lug nuts, it is essential to follow the manufacturer’s recommended torque specifications. The table below outlines the lug nut torque specifications for the 2017 Nissan Sentra:
| Lug Nut Type | Torque Specifications (lb. ft/Nm) |
|---|---|
| Steel Wheels | 80-100 lb. ft / 108-135 Nm |
| Alloy Wheels | 65-80 lb. ft / 88-108 Nm |
Steps to Properly Torque Lug Nuts
To ensure that you correctly torque the lug nuts on your 2017 Nissan Sentra, follow these steps:
1. Prepare the necessary tools: You will need a torque wrench, the appropriate socket size to fit your lug nuts, and a breaker bar if necessary.
2. Loosen the lug nuts: Before lifting your vehicle, use the breaker bar or a lug wrench to slightly loosen the lug nuts. This will make it easier to remove them once the vehicle is lifted.
3. Lift the vehicle: Use a jack to lift your Nissan Sentra off the ground, ensuring that it is securely supported by jack stands.
4. Remove the lug nuts: Completely remove the lug nuts from each wheel and set them aside in a safe place.
5. Clean the wheel studs and mounting surface: Use a wire brush or a clean cloth to remove any dirt or debris from the wheel studs and the mounting surface of the wheel.
6. Install the wheel: Carefully align the wheel with the wheel studs and slide it onto the hub. Make sure it is seated properly.
7. Hand-tighten the lug nuts: Start threading the lug nuts onto the wheel studs by hand. This will prevent cross-threading and ensure that they are properly aligned.
8. Torque the lug nuts: Using a torque wrench, tighten the lug nuts according to the specifications provided in the table above. Start with a lower torque setting and gradually increase until the desired torque is reached.
9. Double-check the torque: After torquing all the lug nuts, go back and double-check each one to ensure they are all properly tightened.
10. Lower the vehicle: Carefully lower your Nissan Sentra back to the ground using the jack, and remove the jack stands.
11. Final check: Once the vehicle is on the ground, give each lug nut a final check to ensure they are still properly torqued.
Conclusion
Properly torquing the lug nuts on your 2017 Nissan Sentra is essential for your safety and the longevity of your wheels. By following the manufacturer’s recommended torque specifications and using the correct tools, you can ensure that your lug nuts are tightened to the appropriate level. Remember to always double-check your work and perform regular maintenance to keep your vehicle in optimal condition.
