2017 Subaru Forester Lug Nut Torque: A Guide to Proper Torquing
Introduction
When it comes to maintaining your vehicle’s safety and performance, paying attention to even the smallest details is crucial. One such detail is the proper torque specification for your Subaru Forester’s lug nuts. In this article, we will provide you with the recommended lug nut torque specs for the 2017 Subaru Forester, ensuring that you can confidently secure your wheels and enjoy a smooth and safe ride.
Understanding Lug Nut Torque
Before diving into the specific torque values, it’s important to understand what lug nut torque is and why it matters. Lug nut torque refers to the amount of force applied to tighten the lug nuts on your vehicle’s wheels. Proper torque ensures that the lug nuts are securely fastened, preventing them from loosening during driving, which could lead to wheel detachment and potential accidents.
2017 Subaru Forester Lug Nut Torque Specifications
To ensure the correct torque is applied to your Subaru Forester’s lug nuts, refer to the table below for the recommended torque values in both pound-feet (lb. ft) and Newton meters (Nm):
| Lug Nut Position | Torque (lb. ft) | Torque (Nm) |
|---|---|---|
| Front and Rear | 89-108 lb. ft | 120-147 Nm |
Steps to Properly Torque Lug Nuts
Now that you have the correct torque specifications, follow these steps to ensure you properly torque your Subaru Forester’s lug nuts:
1. Gather the necessary tools: You will need a torque wrench, a socket that fits your lug nuts, and a breaker bar if necessary.
2. Loosen the lug nuts: Before raising your vehicle, use the breaker bar or a lug wrench to slightly loosen the lug nuts. This will make it easier to remove them once the vehicle is lifted.
3. Lift the vehicle: Use a jack to raise your Subaru Forester off the ground, ensuring it is securely supported by jack stands.
4. Remove the lug nuts: Completely remove the lug nuts and set them aside.
5. Clean the wheel studs: Take a moment to clean the wheel studs to remove any dirt or debris that may affect the torque readings.
6. Install the wheel: Place the wheel onto the wheel studs and hand-tighten the lug nuts until they are snug.
7. Torque the lug nuts: Using the torque wrench and the appropriate socket, tighten the lug nuts in a star or crisscross pattern to ensure even torque distribution. Apply the recommended torque value according to the table above.
8. Double-check the torque: After torquing all the lug nuts, go back and double-check each one to ensure they are properly tightened.
9. Lower the vehicle: Carefully lower your Subaru Forester back to the ground using the jack, and remove the jack stands.
10. Final check: Give each lug nut one last check to ensure they are secure before hitting the road.
Conclusion
Properly torquing your Subaru Forester’s lug nuts is a simple yet essential maintenance task that should not be overlooked. By following the recommended torque specifications and using the correct techniques, you can ensure the safety and longevity of your vehicle’s wheels. Remember to always consult your vehicle’s manual or a trusted source for the most accurate and up-to-date torque values. Safe travels!
