2018 Subaru Outback Lug Nut Torque: Proper Torque Specifications and Steps

2018 Subaru Outback Lug Nut Torque

Introduction

When it comes to maintaining your vehicle, one crucial aspect is ensuring that the lug nuts on your wheels are properly tightened. The correct torque specification for lug nuts is essential for the safety and performance of your Subaru Outback. In this article, we will discuss the recommended lug nut torque for the 2018 Subaru Outback and provide a table with torque specifications in lb. ft and Nm.

Lug Nut Torque Specifications

To ensure that your lug nuts are tightened to the appropriate torque, refer to the table below for the specific torque specifications for the 2018 Subaru Outback:

Wheel Size Torque Specification (lb. ft) Torque Specification (Nm)
16-inch 80-90 108-122
17-inch 80-90 108-122
18-inch 80-90 108-122

Steps to Properly Torque Lug Nuts

To ensure that you correctly torque the lug nuts on your 2018 Subaru Outback, follow these steps:

  1. Start by parking your vehicle on a flat surface and engaging the parking brake.
  2. Using a lug wrench or a torque wrench, loosen each lug nut on the wheel you are working on, but do not remove them completely.
  3. Position the jack under the appropriate jacking point and lift the vehicle until the wheel is off the ground.
  4. Remove the loosened lug nuts and take off the wheel.
  5. Clean the wheel hub and the mounting surface on the brake rotor or drum to ensure proper contact.
  6. Place the wheel back onto the hub, aligning the lug nut holes with the studs.
  7. Hand-tighten each lug nut until they are snug.
  8. Using a torque wrench, tighten each lug nut in a star or crisscross pattern to the specified torque value according to the table above.
  9. After torquing all the lug nuts, double-check the torque by going over them again in the same pattern.
  10. Lower the vehicle back to the ground and remove the jack.
  11. Finally, using a torque wrench, recheck the lug nut torque after driving a short distance to ensure they have not loosened.

Conclusion

Properly torquing the lug nuts on your 2018 Subaru Outback is crucial for your safety and the longevity of your vehicle. By following the recommended torque specifications and the steps outlined in this article, you can ensure that your lug nuts are tightened correctly. Remember to always consult your vehicle’s owner’s manual for any specific instructions or torque values.

Author

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top