2016 CRV Lug Nut Torque Specifications
Introduction
When it comes to maintaining your vehicle’s safety and performance, it is crucial to ensure that all components are properly tightened. One such component that requires attention is the lug nuts. Lug nuts are responsible for securing the wheels to the vehicle’s hub, and it is important to tighten them to the manufacturer’s recommended torque specifications. In this article, we will discuss the lug nut torque specifications for the 2016 CRV, providing you with the necessary information to ensure your wheels are properly secured.
Lug Nut Torque Specifications
To prevent over-tightening or under-tightening of lug nuts, it is essential to adhere to the recommended torque specifications. The table below outlines the lug nut torque specifications for the 2016 CRV in both pound-feet (lb. ft) and Newton meters (Nm):
| Lug Nut Position | Torque Specifications (lb. ft) | Torque Specifications (Nm) |
|---|---|---|
| Front and Rear | 80 lb. ft | 108 Nm |
Steps to Properly Torque Lug Nuts
To ensure the lug nuts are tightened correctly, follow these steps:
- Start by parking your CRV on a flat surface and engaging the parking brake.
- Using a lug wrench or a torque wrench, loosen the lug nuts on all wheels before lifting the vehicle.
- Using a jack, lift the CRV until the wheels are off the ground.
- Remove the loosened lug nuts and wheels.
- Clean the wheel hub and the mounting surface to remove any dirt or debris.
- Place the wheel back onto the hub and hand-tighten the lug nuts in a star pattern to ensure even tightening.
- Using a torque wrench, tighten the lug nuts to the specified torque specifications mentioned in the table above.
- Once all lug nuts are properly torqued, lower the vehicle and remove the jack.
- Finally, using the torque wrench, recheck the lug nut torque after driving a short distance to ensure they have not loosened.
Conclusion
Properly torquing the lug nuts on your 2016 CRV is crucial for your safety and the longevity of your vehicle. By following the recommended torque specifications and using the correct torque wrench, you can ensure that your wheels are securely fastened. Remember to periodically check the lug nut torque to prevent any potential issues.
