2017 Honda CRV Lug Nut Torque: A Comprehensive Guide
Introduction
When it comes to maintaining your vehicle, one crucial aspect is ensuring that the lug nuts are properly torqued. The lug nuts are responsible for securing the wheels to the vehicle, and incorrect torque can lead to various issues, including wheel misalignment, vibrations, and even accidents. In this article, we will delve into the lug nut torque specifications for the 2017 Honda CRV, providing you with the necessary information to keep your vehicle safe and in optimal condition.
Lug Nut Torque Specifications
To ensure the lug nuts are tightened to the appropriate torque, it is essential to refer to the manufacturer’s specifications. Below is a table outlining the lug nut torque specifications for the 2017 Honda CRV, measured in pound-feet (lb. ft) and Newton meters (Nm):
| Lug Nut Position | Torque (lb. ft) | Torque (Nm) |
|---|---|---|
| Front | 80 | 108 |
| Rear | 80 | 108 |
Steps to Properly Torque Lug Nuts
Now that you have the torque specifications, let’s go through the steps to properly torque the lug nuts on your 2017 Honda CRV:
- Start by parking your vehicle on a flat surface and engaging the parking brake.
- Using a lug wrench or a suitable socket and torque wrench, loosen each lug nut on the wheel you intend to work on, but do not remove them completely.
- Position the jack under the vehicle’s designated jacking point and raise the wheel off the ground. Ensure the vehicle is stable and secure before proceeding.
- Remove the loosened lug nuts and take off the wheel.
- Clean the wheel hub and the mounting surface to remove any dirt, debris, or rust that may interfere with proper torque.
- Place the wheel back onto the hub, aligning the lug nut holes with the studs.
- Hand-tighten the lug nuts in a star or crisscross pattern to ensure even pressure distribution.
- Using a torque wrench, tighten the lug nuts to the specified torque in the table above. Start with a lower setting and gradually increase until reaching the desired torque.
- Once all lug nuts are torqued, double-check their tightness by re-torquing them in the same pattern.
- Lower the vehicle from the jack, and using the torque wrench, recheck the lug nut torque after a short drive to ensure they have not loosened.
Conclusion
Properly torquing the lug nuts on your 2017 Honda CRV is vital for the safety and performance of your vehicle. By adhering to the manufacturer’s specifications and following the steps outlined in this article, you can ensure that your wheels are securely fastened. Remember to regularly inspect and torque your lug nuts to maintain optimal driving conditions and prevent any potential issues. Stay safe on the road!
