2019 Ram 2500 Lug Nut Torque: A Guide to Proper Torque Specifications
Introduction
When it comes to maintaining your vehicle, one crucial aspect is ensuring that your lug nuts are properly tightened. In the case of the 2019 Ram 2500, it is essential to follow the recommended torque specifications to guarantee the safety and longevity of your vehicle’s wheels. This article will provide you with the necessary information on the lug nut torque specifications for the 2019 Ram 2500.
Lug Nut Torque Specifications
To ensure the correct torque is applied to your Ram 2500’s lug nuts, it is important to refer to the manufacturer’s recommended specifications. The table below outlines the lug nut torque specifications for the 2019 Ram 2500 in both pound-feet (lb. ft) and Newton-meters (Nm):
| Lug Nut Position | Torque (lb. ft) | Torque (Nm) |
|---|---|---|
| Front and Rear Wheel Lug Nuts | 130 lb. ft | 176 Nm |
| Spare Wheel Lug Nuts | 130 lb. ft | 176 Nm |
Proper Lug Nut Torquing Procedure
To ensure the lug nuts are tightened correctly, follow these steps:
- Ensure the vehicle is on a level surface and the parking brake is engaged.
- Using a lug wrench or torque wrench, loosen each lug nut on the wheel in a crisscross pattern before lifting the vehicle.
- Once the lug nuts are loosened, use a jack to lift the vehicle off the ground, ensuring it is secure on jack stands.
- Remove the lug nuts and the wheel.
- Clean the wheel studs and the mounting surface to remove any dirt or debris.
- Place the wheel back onto the mounting surface, aligning the holes with the studs.
- Hand-tighten each lug nut until they are snug.
- Using a torque wrench, tighten each lug nut to the specified torque in a crisscross pattern.
- Double-check the torque by re-tightening each lug nut in the same crisscross pattern.
- Lower the vehicle from the jack stands and remove the jack.
- Finally, check the lug nuts again after driving a short distance to ensure they remain properly torqued.
Conclusion
Properly torquing the lug nuts on your 2019 Ram 2500 is crucial for the safety and performance of your vehicle. By following the manufacturer’s recommended torque specifications and using the correct torquing procedure, you can ensure that your wheels are securely fastened. Remember to periodically check the lug nut torque to maintain the integrity of your vehicle’s wheels and prevent any potential issues on the road.
