2016 Subaru Outback Lug Nut Torque: Proper Torque Specifications for Wheel Lug Nuts
Introduction
When it comes to maintaining your vehicle’s safety and performance, paying attention to even the smallest details is crucial. One such detail is the torque specifications for your Subaru Outback’s lug nuts. Properly torquing your lug nuts ensures that your wheels are securely fastened, preventing accidents and potential damage to your vehicle. In this article, we will provide you with the recommended lug nut torque specifications for the 2016 Subaru Outback.
Lug Nut Torque Specifications
To ensure the correct torque is applied to your Subaru Outback’s lug nuts, it is important to refer to the manufacturer’s specifications. The table below provides the recommended torque values in both pound-feet (lb. ft) and Newton-meters (Nm) for the 2016 Subaru Outback:
| Lug Nut Size | Torque Specifications (lb. ft) | Torque Specifications (Nm) |
|---|---|---|
| 12mm x 1.25 | 70-80 lb. ft | 95-108 Nm |
| 12mm x 1.5 | 70-80 lb. ft | 95-108 Nm |
| 14mm x 1.25 | 85-95 lb. ft | 115-129 Nm |
| 14mm x 1.5 | 85-95 lb. ft | 115-129 Nm |
Proper Lug Nut Torquing Procedure
Now that you have the torque specifications, it is essential to follow the correct procedure when torquing your Subaru Outback’s lug nuts. Here are the steps to ensure a proper lug nut torquing:
1. Start by ensuring that your vehicle is on a level surface and the parking brake is engaged.
2. Use a lug wrench or a torque wrench to loosen the lug nuts on each wheel before lifting the vehicle with a jack.
3. Once the vehicle is safely lifted, remove the lug nuts and the wheels.
4. Clean the wheel studs and lug nuts to remove any dirt or debris that may affect the torque readings.
5. Place the wheel back onto the wheel studs and hand-tighten the lug nuts in a star pattern to ensure even pressure distribution.
6. Use a torque wrench to tighten the lug nuts to the specified torque value in the recommended sequence. This sequence is typically tightening them in a star or crisscross pattern.
7. Double-check the torque on each lug nut to ensure they are all properly torqued.
8. Lower the vehicle back to the ground and use the torque wrench to recheck the lug nut torque after a short drive to ensure they have not loosened.
Conclusion
Properly torquing your Subaru Outback’s lug nuts is a critical step in maintaining the safety and performance of your vehicle. By following the manufacturer’s torque specifications and using the correct torquing procedure, you can ensure that your wheels are securely fastened. Remember to always refer to your vehicle’s specific torque specifications and consult your owner’s manual if you have any doubts or questions. Stay safe on the road by paying attention to even the smallest details, such as lug nut torque.
