2020 Subaru Forester Lug Nut Torque: Proper Torque Specifications for Wheel Lug Nuts
Introduction
When it comes to maintaining your vehicle’s safety and performance, paying attention to even the smallest details is crucial. One such detail is the proper torque specification for your Subaru Forester’s lug nuts. Torquing the lug nuts to the correct specification ensures that your wheels are securely fastened, preventing accidents and potential damage to your vehicle. In this article, we will provide you with the recommended torque specifications for the lug nuts on a 2020 Subaru Forester.
Torque Specifications
To ensure the correct torque is applied to your Subaru Forester’s lug nuts, it is essential to refer to the manufacturer’s specifications. Below is a table outlining the recommended torque specifications for the lug nuts on a 2020 Subaru Forester:
| Lug Nut Size | Torque Specification (lb. ft) | Torque Specification (Nm) |
|---|---|---|
| 12mm x 1.25 | 70-80 lb. ft | 95-110 Nm |
| 12mm x 1.5 | 70-80 lb. ft | 95-110 Nm |
| 14mm x 1.25 | 85-95 lb. ft | 115-130 Nm |
| 14mm x 1.5 | 85-95 lb. ft | 115-130 Nm |
Steps to Properly Torque Lug Nuts
Now that you know the recommended torque specifications for your Subaru Forester’s lug nuts, let’s go through the steps to properly torque them:
1. Start by ensuring that your vehicle is parked on a level surface and the parking brake is engaged.
2. Using a lug wrench or a torque wrench, loosen each lug nut on the wheel you are working on, but do not remove them completely.
3. Once all the lug nuts are loosened, use a jack to lift the vehicle until the wheel is off the ground. Place jack stands under the vehicle for added safety.
4. Completely remove the lug nuts and carefully take off the wheel.
5. Clean the wheel studs and the mounting surface on the hub to remove any dirt or debris.
6. Place the wheel back onto the hub, aligning the wheel studs with the lug nut holes.
7. Thread each lug nut onto the wheel studs by hand, ensuring they are properly aligned and tightened as much as possible.
8. Using a torque wrench, tighten each lug nut in a star or crisscross pattern to the recommended torque specification according to the table provided above.
9. Once all the lug nuts are torqued, double-check each nut to ensure they are properly tightened.
10. Lower the vehicle back to the ground using the jack and remove the jack stands.
11. Finally, using a torque wrench, recheck the lug nut torque after driving approximately 50-100 miles to ensure they have not loosened.
Conclusion
Properly torquing the lug nuts on your 2020 Subaru Forester is essential for your safety and the longevity of your vehicle. By following the recommended torque specifications and the steps outlined in this article, you can ensure that your wheels are securely fastened. Remember to always consult your vehicle’s owner’s manual or contact a professional if you have any doubts or questions regarding lug nut torque.
