2017 Ford Focus Lug Nut Torque: Proper Torque Specifications for Safety and Performance
The lug nuts on your vehicle play a crucial role in keeping your wheels securely attached to the axle. It is essential to tighten them to the correct torque specification to ensure safety and optimal performance. In this article, we will discuss the recommended lug nut torque for the 2017 Ford Focus, providing you with the necessary information to maintain your vehicle’s wheels properly.
Understanding Lug Nut Torque
Lug nut torque refers to the amount of force applied to tighten the lug nuts on your vehicle’s wheels. It is measured in pound-feet (lb. ft) or Newton meters (Nm). Proper torque ensures that the lug nuts are tightened enough to prevent them from loosening during driving but not excessively tightened, which can lead to damage or breakage.
2017 Ford Focus Lug Nut Torque Specifications
When it comes to the lug nut torque for the 2017 Ford Focus, it is crucial to follow the manufacturer’s recommendations. The table below provides the lug nut torque specifications in both pound-feet (lb. ft) and Newton meters (Nm) for different models of the 2017 Ford Focus:
| Model | Lug Nut Torque (lb. ft) | Lug Nut Torque (Nm) |
|---|---|---|
| S Sedan | 100 lb. ft | 135 Nm |
| SE Sedan | 100 lb. ft | 135 Nm |
| Titanium Sedan | 100 lb. ft | 135 Nm |
| ST Hatchback | 100 lb. ft | 135 Nm |
| RS Hatchback | 100 lb. ft | 135 Nm |
Proper Lug Nut Torque Procedure
Now that you know the recommended lug nut torque for your 2017 Ford Focus, it is essential to follow the proper procedure to ensure accurate and consistent tightening. Here are the steps to follow:
- Start by using a torque wrench to loosen the lug nuts on each wheel.
- Once the lug nuts are loosened, use a jack to lift the vehicle off the ground, ensuring it is secure on jack stands.
- Remove the lug nuts and wheels from the vehicle.
- Clean the wheel studs and hub surface to remove any dirt or debris.
- Place the wheel back onto the hub, aligning the lug nut holes.
- Hand-tighten the lug nuts until they are snug.
- Using a torque wrench, tighten the lug nuts in a star pattern, gradually increasing the torque until you reach the specified value.
- Double-check the torque on each lug nut to ensure consistency.
- Lower the vehicle from the jack stands and use the torque wrench to recheck the lug nut torque after a short drive.
Following these steps will help you achieve the proper lug nut torque for your 2017 Ford Focus, ensuring the safety and performance of your vehicle’s wheels.
Conclusion
Proper lug nut torque is crucial for the safety and performance of your 2017 Ford Focus. By following the manufacturer’s recommended torque specifications and using the correct procedure to tighten the lug nuts, you can ensure that your wheels stay securely attached to the axle. Regularly checking and maintaining the lug nut torque will provide you with peace of mind during your drives and help prevent any potential issues caused by loose or overtightened lug nuts.
