2017 Ford Fusion Lug Nut Torque Specifications
Introduction
When it comes to maintaining your vehicle, it is crucial to ensure that all components are properly tightened and secured. One such component that requires attention is the lug nuts on your Ford Fusion’s wheels. Lug nuts are responsible for keeping your wheels attached to the vehicle, and it is important to torque them to the manufacturer’s specifications to ensure safety and prevent damage. In this article, we will provide you with the recommended lug nut torque specifications for the 2017 Ford Fusion.
Lug Nut Torque Specifications
The lug nut torque specifications for the 2017 Ford Fusion vary depending on the trim level and wheel size. It is essential to use the correct torque value to avoid over-tightening or under-tightening the lug nuts. Below is a table that outlines the torque specifications in both pound-feet (lb. ft) and Newton meters (Nm):
| Trim Level | Wheel Size | Torque Specs (lb. ft) | Torque Specs (Nm) |
|---|---|---|---|
| S | 16-inch wheels | 100-110 lb. ft | 135-150 Nm |
| SE | 17-inch wheels | 100-110 lb. ft | 135-150 Nm |
| Titanium | 18-inch wheels | 100-110 lb. ft | 135-150 Nm |
| Platinum | 19-inch wheels | 100-110 lb. ft | 135-150 Nm |
Proper Lug Nut Torquing Procedure
To ensure that the lug nuts are torqued correctly, follow these steps:
- Start by parking your Ford Fusion on a level surface and engage the parking brake.
- Using a lug wrench or a torque wrench, loosen each lug nut on the wheel you intend to work on, but do not remove them completely.
- Consult the table above to determine the appropriate torque specification for your specific trim level and wheel size.
- Using a torque wrench, tighten each lug nut in a crisscross pattern gradually. This pattern ensures even distribution of torque and prevents warping of the brake rotor.
- Continue tightening until you reach the recommended torque value specified in the table.
- Repeat the process for each wheel on your Ford Fusion.
- After torquing all the lug nuts, double-check the tightness by re-torquing them in the same crisscross pattern.
Conclusion
Properly torquing the lug nuts on your 2017 Ford Fusion is crucial for your safety and the longevity of your vehicle. By following the recommended torque specifications provided in this article and using the correct torquing procedure, you can ensure that your wheels are securely fastened. Remember to periodically check the lug nut torque and retorque them if necessary, especially after tire rotations or wheel removals.
