Proper Lug Nut Torque for 2011 Subaru Outback

2011 Subaru Outback Lug Nut Torque Specifications

Introduction

When it comes to maintaining your vehicle, it is essential to ensure that all components are properly tightened to guarantee safety and prevent any potential issues. One crucial aspect to consider is the torque specifications for your lug nuts. In this article, we will provide you with the recommended lug nut torque for a 2011 Subaru Outback.

Lug Nut Torque Specifications

To ensure the correct torque is applied to your Subaru Outback’s lug nuts, refer to the table below:

Lug Nut Torque (lb. ft) Torque (Nm)
Front and Rear 88-108 120-147

Steps to Properly Torque Lug Nuts

To ensure the lug nuts are tightened correctly, follow these steps:

  1. Start by parking your Subaru Outback on a flat surface and engaging the parking brake.
  2. Locate the lug wrench and the jack provided with your vehicle.
  3. Using the lug wrench, loosen each lug nut on all four wheels by turning them counterclockwise. Do not remove the lug nuts completely at this stage.
  4. Position the jack under the designated jacking point of the vehicle, usually indicated in the owner’s manual.
  5. Slowly raise the vehicle using the jack until the tire is off the ground.
  6. Remove the lug nuts completely and take off the wheel.
  7. Inspect the wheel and brake components for any signs of damage or wear.
  8. Place the wheel back onto the hub, aligning the holes with the studs.
  9. Thread the lug nuts onto the studs by hand, ensuring they are snug but not fully tightened.
  10. Using a torque wrench, set it to the recommended torque value specified in the table above.
  11. Tighten each lug nut in a star pattern, alternating between nuts to ensure even pressure distribution.
  12. Once all lug nuts are tightened to the specified torque, double-check each nut to ensure they are secure.
  13. Lower the vehicle back to the ground using the jack.
  14. Using the lug wrench, give each lug nut a final check to ensure they are tightened properly.

Conclusion

Properly torquing the lug nuts on your 2011 Subaru Outback is crucial for your safety and the longevity of your vehicle. By following the recommended torque specifications and the steps outlined in this article, you can ensure that your lug nuts are tightened correctly. Remember to always consult your vehicle’s owner’s manual for any specific instructions or torque values.

Author

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top