2017 Toyota Tacoma Lug Nut Torque: Proper Torque Specs for Your Vehicle
Introduction
When it comes to maintaining your vehicle, paying attention to even the smallest details is crucial. One such detail is the torque specification for your Toyota Tacoma’s lug nuts. Properly torquing your lug nuts ensures the safety of your vehicle and prevents any potential issues down the road. In this article, we will provide you with the recommended torque specs for the lug nuts on a 2017 Toyota Tacoma.
Lug Nut Torque Specifications
To ensure the correct torque is applied to your Toyota Tacoma’s lug nuts, refer to the table below for the torque specifications in both pound-feet (lb. ft) and Newton meters (Nm):
| Lug Nut Position | Torque Specs (lb. ft) | Torque Specs (Nm) |
|---|---|---|
| Front and Rear Wheel Lug Nuts | 85-95 lb. ft | 115-129 Nm |
Steps to Properly Torque Lug Nuts
To ensure the lug nuts are torqued correctly, follow these steps:
- Start by parking your Toyota Tacoma on a level surface and engaging the parking brake.
- Using a lug wrench or a suitable socket, loosen each lug nut on the wheel you are working on, but do not remove them completely.
- Position a jack under the designated jacking point and lift the vehicle until the wheel is off the ground.
- Completely remove the lug nuts and carefully take off the wheel.
- Clean the wheel hub and the mounting surface to ensure proper contact.
- Place the wheel back onto the hub and hand-tighten the lug nuts in a star pattern to ensure even tightening.
- Using a torque wrench, set it to the recommended torque specification for your Toyota Tacoma (85-95 lb. ft or 115-129 Nm).
- Tighten each lug nut in a star pattern, gradually increasing the torque until reaching the specified value.
- Double-check the torque on each lug nut to ensure they are all properly tightened.
- Lower the vehicle using the jack and remove the jack from under the vehicle.
- Finally, using a torque wrench, recheck the lug nuts after driving approximately 50 miles to ensure they have not loosened.
Conclusion
Properly torquing the lug nuts on your 2017 Toyota Tacoma is essential for the safety and longevity of your vehicle. By following the recommended torque specifications and the steps outlined above, you can ensure that your lug nuts are tightened correctly. Remember to always consult your vehicle’s owner’s manual for specific torque specifications and any additional instructions.
